Quick start guide

../_images/we300.png

1. Overview

This document provides the necessary information for starting-up the device and log in into the web interface.

Further information regarding the web interface and the functionality of the WE300, can be obtained from the official WE300 documentation.


2. Inserting the SIM card

Whith the device turned-off, insert the SIM card as shown in the diagram.

Connect the antenna and the RJ-45 Ethernet cable to the proper connectors. Be sure that the device is not powered before inserting the SIM card.


3. Turning-on the device

Connect the power source (12-24 VDC /1 A) to the terminal +Vin e GND. The Power LED will be turned on immediately.

../_images/vista_laterale.png

After approximately 40 seconds the system will become fully operative. When a GPRS connection is established, the GPRS LED will be turned-on, otherwise it will blink or will be turned off.

../_images/serigrafia.png

4. Logging in

The default network configuration for connecting to the WE300 is:

  • IP address: 192.168.1.160
  • Netmask: 255.255.255.0
  • Gateway: 192.168.1.1
  • Dns: 8.8.8.4

It is necessary that the PC used for connecting to the WE300 belongs to the same network 192.168.1.x. For connecting to the WE300, use a standard web browser and enter the following address in the URL bar:

192.168.1.160

../_images/login1.png

The authentication procedure of the web interface will ask for the user credentials. The default username and password are the following:

  • Username: admin
  • Password: admin

Hint

It’s strongly recommended to change the default password after the first login.

Hint

Complete manual available at http://nethix.co/doc/en/we300/we300_sw_manual.html